Term
|
Definition
1. Laser-Off 2. MMS- STBY / Off 3. ACP- Swtiches Set 4. Landing Light - Set as Required 5. CCP safe/arm switch - SAFE (CMWS) 6. Performance Considerations - As Required |
|
|
Term
|
Definition
PAC- Power Assurance Check _ ETF less than .95 is NO-GO ENG/XMSN - check in Limits Flight Instruments - Check Hover Power - Check |
|
|
Term
Prior to conducting FADEC system check the pilot must verify____? |
|
Definition
pilot shall confirm the S GEN LD % is less then 70%
with the S GEN LD greater than 70% the NG change will not be accurate |
|
|
Term
ENG run-up Navigation system - configure as required. What are the sub-steps? |
|
Definition
a. waypoints, control points, & targets - check/load b. Routes - Check/Construct c. Battlefield Graphics - Check/Construct d. HSD-, HSD+, and RMS - As Required |
|
|
Term
|
Definition
1. avionics-as required 2. NR 100% 3. Systems-check,fuel,ENG,XMSN,Elec,CWAs review 4. ACP-switches set 5. CPO-cyclic engaged as required 6. Crew, passengers, mission equipment, seat belt, armor side panels-check |
|
|
Term
|
Definition
Landing Light-Off as required Transponder-STBY as required ASE-set as required Avionics-as required |
|
|
Term
During FADEC System Check if NG increases by more than 12%? |
|
Definition
If NG RPM increases more than 12% from the initial ground idle setting then perform normal shutdown |
|
|
Term
During FADEC System check if engine Auto-accelerates? |
|
Definition
If engine auto accelerates. Emergency Shutdown to avoid engine overspeed |
|
|
Term
Engine Starting Call Outs? |
|
Definition
Batt Volts- 14 by 10% NG TGT- on rise by 18% NG ENG Oil Pressure- Rising by 20% NG Rotor Blades-turning by 25% NG Start V- decreased to near 0 at 50% NG NG-check stablized at idle 63-65% |
|
|
Term
|
Definition
Weapons Systems-Safe a. Ejector Rack- Pins Installed b.Weapons Load Status - Verify c. Hellfire launcher Safe/Arm - Safe d. Master Arm switch- Off e. Jettison switches - Cover Down f. IZLID Laser switch - Off 2. LASER ARM/STBY/OFF switch - Off 3. Right Side Intermediate Fuselage. CMWS safety pin - Installed and locked 4. CMWS Control Panel (CCP) Safe/Arm swithch - SAFE 6. Publications - Check as Required 7. Covers, locking devices, tiedowns, and ground cables - Removed as required 8. Main Rotor - Check 9. Ignition keylock swithch - On |
|
|
Term
|
Definition
IGN CB switch - Off Fuel Boost switch - Off ENSTL BUS switch - Start BATT 1 switch - Batt 1 Lights - Check MPD - Check Battery voltage 21volts & Fuel quantity CWA messages -Review & Acknowledge FADEC MONITOR & ENGINE HISTORY Pages- Check NVG Power Converters - Check ECSU - Check Batt 1 Switch - OFF |
|
|
Term
|
Definition
|
|