Term
How are the
flaps powered?
|
|
Definition
|
|
Term
How are the
speedbrakes powered?
|
|
Definition
|
|
Term
How is a roll
controlled?
|
|
Definition
Ailerons and 3 roll spoilers |
|
|
Term
Which yoke control
ailerons or spoilers?
|
|
Definition
Left pilot control ailerons
Right pilot control spoilers |
|
|
Term
What panels are used
as speedbrakes? |
|
Definition
|
|
Term
What is the purpose of
the aileron ration changer? |
|
Definition
Provides mechanical advantage to move
the ailerons, especially at high speed |
|
|
Term
By what percentage does the
aileron ratio changer
reduces forces on the yoke?
|
|
Definition
10% at slow speed
30% at 270 Kts |
|
|
Term
What happens to the ratio
changer when loss of DC?
|
|
Definition
Fails at present position |
|
|
Term
On what bus is the
aileron trim?
|
|
Definition
|
|
Term
What happens to the autopilot
when the roll disconnect
handle is pulled?
|
|
Definition
|
|
Term
Which speedbrakes panels
are either fully deployed
or fully stowed?
|
|
Definition
First and last panel
on each wing
(1, 5- 6, 10) |
|
|
Term
What is the speedbrakes
limitation?
|
|
Definition
Must be stowed by 500 ft AGL |
|
|
Term
What happens when the
flaps handle is
stopped between positions?
|
|
Definition
Flaps fail cas message
Reset switch illuminated
|
|
|
Term
On what bus is the primary
stabilizer trim actuator?
|
|
Definition
|
|
Term
On what bus is the
secondary trim actuator?
|
|
Definition
|
|
Term
What are the two ways
of using the trim in pitch axis?
|
|
Definition
a) Primary trim on the yoke
b) Secondary trim on the center pedestal |
|
|
Term
When do you use
secondary trim?
|
|
Definition
When primary trim is inop |
|
|
Term
What powers the
Mach trim?
|
|
Definition
|
|
Term
What is the function of
the Mach trim system?
|
|
Definition
Increase control forces at high speed
to compensate for the aircraft
tendency to pitch down |
|
|
Term
What is the Mach
trim limitation?
|
|
Definition
Mach trim must be working for
speeds above Mach 0.77 if hand flying |
|
|
Term
|
Definition
|
|
Term
Why is main DC required
for the rudder bias, when the
system use bleed air?
|
|
Definition
Controller need main DC to take input
from ADC to position the actuator |
|
|
Term
Until what speed will rudder
bias allow full rudder travel?
|
|
Definition
125 Kts
Start restricting rudder travel above that |
|
|
Term
When will rudder bias move
to its minimum position?
|
|
Definition
a) Above 250 Kts
b) TR's deployment
c) Emer stow
d) Override switch |
|
|
Term
When would you use the
override switch on
the rudder bias?
|
|
Definition
Uncommanded rudder deflection
Moving to its minimum length reduce
force to a minimum |
|
|
Term
What is the advantage of
having a rudder bias?
|
|
Definition
|
|
Term
On what bus is the
rudder bias override?
|
|
Definition
|
|
Term
What happens to the rudder
bias with loss of DC?
|
|
Definition
|
|
Term
On what bus is the
rudder trim?
|
|
Definition
|
|
Term
How many boundary layer
energizers (BLE) are on
each wing and what
are they for?
|
|
Definition
9
Back up to the AOA prior to stall |
|
|
Term
How many static
wicks total and how
many can be missing?
|
|
Definition
17 total
2 can be missing |
|
|
Term
How many vortex generators
and how many can
be missing?
|
|
Definition
44 total
16 can be missing |
|
|
Term
What happens to the elevators
when setting the flaps
beyond 15 degrees?
|
|
Definition
Automatically trimmed by the flap/stabilizer interconnect system, regardless of
autopilot on or off |
|
|
Term
When will the trim audio
clacker sounds?
|
|
Definition
a) When the autopilot
trims for 3 seconds
b) When using the secondary
trim for 3 seconds
c) When there is a runaway
trim for 1 second |
|
|
Term
Will the trim audio clacker sound using the primary trim?
|
|
Definition
|
|
Term
Which secondary controls
are electric?
|
|
Definition
|
|
Term
Why do the trims use 2 halves
to compose the switch?
|
|
Definition
One half set power, other half applies it
Runaway prevention |
|
|
Term
When do the
spoilers deploy?
|
|
Definition
|
|
Term
How do you get a flap
assymmetrical protection?
|
|
Definition
System shuts off if more
than 5% split |
|
|
Term
Can you turn off
rudder bias?
|
|
Definition
No, the best you can do is use override
to drive the actuator down to minimum |
|
|
Term
At what position is the rudder
bias actuator for takeoff?
|
|
Definition
|
|
Term
What is the reason for having a
"red stab no t/o" annunciator?
|
|
Definition
Stab pointer can be adjusted by maintenance
and may show green even when
stab not in proper place |
|
|
Term
At what speed does the
secondary trim moves? |
|
Definition
Half the speed of the primary trim |
|
|
Term
What is the common part
between the primary
and secondary trim?
|
|
Definition
Same actuator but different motors |
|
|
Term
How many degrees does
the stab trim move?
|
|
Definition
|
|
Term
On preflight,what gap should
you see between elevators
when the stabilizer is
set to -6.9 degrees? |
|
Definition
1 inch
Should never be flush with the elevator |
|
|
Term
What is the function of
the stab trim tab?
|
|
Definition
Keep elevators streamlined
with leading edge |
|
|
Term
What does the Mach trim
do to the stab trim tab?
|
|
Definition
Move the tab 1 degree to offset
a slight Mach tuck |
|
|
Term
What is the memory item for a rudder runaway?
|
|
Definition
Press and hold the AP/TRIM/NWS
disc button |
|
|
Term
What is the memory item
for a jammed control?
|
|
Definition
a) Trim to desired pitch attitude
b) Relax pressure on yoke
c) Pull and latch the pitch/roll
disconnect handle
d) Identify, recover aircraft attitude |
|
|
Term
What is the memory item for a primary pitch trim runaway? |
|
Definition
Press and hold AP/TRIM/NWS
disconnect button |
|
|
Term
What is the memory item for a secondary pitch trim runaway? |
|
Definition
Lift cover guard secondary pitch trim
and select OFF |
|
|
Term
What is the memory item
for an aileron trim runaway? |
|
Definition
Press and hold AP/TRIM/NWS
disconnect button |
|
|
Term
How do you know if gust lock
handle lock is still engaged?
|
|
Definition
a) Right throttle restricted to 20% thrust
b) Advancing the left throttle beyond
the right one will trigger a no T/O warning |
|
|
Term
What powers the
stab trim tab?
|
|
Definition
|
|
Term
How long does it take for
the flaps to go full deflection?
|
|
Definition
|
|
Term
You went the wrong way
using the pitch/roll
disconnect handle. Now what?
|
|
Definition
a) Go to 9 o'clock position
(Pitch/roll reconnect)
b) Push down to reset
c) Go to 3 o'clock
(norm) |
|
|
Term
What check-list call for landing
at 150 Kts, and therefore increase landing distance by 2.34?
|
|
Definition
Jammed stabilizer trim at high speed cruise |
|
|
Term
How many degrees do you need to input on the yoke to start
using the spoilers?
|
|
Definition
|
|
Term
What do you do with the pitch/roll disconnect T-handle if no jam is found in the roll system?
|
|
Definition
Reconnect the ailerons/spoilers by
turning the handle to roll
reconnect position (6 o'clock) |
|
|
Term
What do you do with the pitch/roll
disconnect handle if the roll is jammed? |
|
Definition
Rotate the handle to pitch reconnect
(noon position) |
|
|
Term
What do you do with the pitch/roll
disconnect handle if the pitch is jammed? |
|
Definition
Go to roll reconnect
(6 o'clock position) |
|
|
Term
True or false: as speed increases,
the aileron ratio changer decreases
aileron travel in relation to control input |
|
Definition
|
|
Term
Does the mach trim increases or
decreases the aircraft pitch up forces
above Mach 0.77? |
|
Definition
|
|
Term
What is the T/O pitch trim
setting designed for? |
|
Definition
Designed for a trimmed position at V2 |
|
|
Term
What is the position of the
rudder bias actuator arm
in low speed? |
|
Definition
|
|
Term
Is the rudder deflection increased
or reduced by the rudder bias
during low speed? |
|
Definition
|
|
Term
Is the rudder deflection increased
or reduced during high speed? |
|
Definition
|
|
Term
Are roll spoilers deployment
displayed on the EICAS in flight? |
|
Definition
|
|
Term
How many static wicks can be
missing on the flight controls? |
|
Definition
1- Never more than one (out of the 3 or 4 installed)
2- No more than 2 can be missing for the whole aircraft
AFM, operating limitations section 2 |
|
|