Term
| These buses are often used for the headphone mix |
|
Definition
|
|
Term
| How do you give a musician playing X instrument more volume of him/herself in the headphone mix? |
|
Definition
- Find the X instrument track
- Find Sends panel
- Find the aux send for the room where the musician is tracking X
- Raise that fader |
|
|
Term
| How do you give the vocalist less of the band? |
|
Definition
EITHER:
- Find vox track, click on the send to the vox isolation area, raise that fader |
|
|
Term
| How do you place a headphone mix on all tracks? |
|
Definition
| Hold down the option key while choosing a send that goes with the headphone mix (such as Bus 27-28); this will place that send on all tracks. |
|
|
Term
| How do you locate the FMP button? |
|
Definition
| Locate this by clicking the "send" rectangle graphic, then look to the right of the "safe" and "pre" buttons. |
|
|
Term
| What should you remember when adding sends (such as headphone mixes) to additional tracks? |
|
Definition
| Copy sends from mono tracks to mono tracks, stereo tracks to stereo tracks. |
|
|
Term
| 4 steps to set up a talkback channel? |
|
Definition
(not totally sure this is correct--check)
1. Find the Talkback Aux track
2. Give it a stereo input, like Console 23+24R
3. Run a T cable from the patchbay that goes with that input to console patchbay 32 "Channel Out," sending the talkback audio to channel 32 on the soundboard
4. Set the physical console fader to about -5 dB |
|
|
Term
| What patch does Console 23+24R go with on the console patchbay? |
|
Definition
|
|
Term
| How do you set up a headphone mix for someone recording in the drum room, for example? |
|
Definition
Cabinet patchbay/Pro Tools Out 27-28 <<2 T cables>> Cabinet patchbay/Drum room patchbay 11-12
AND
drum-patchbay 11-12 <<2 XLR cables>>
L/R on back of headphone amplifier in drum room |
|
|
Term
| What do you need to do before you can use the headphone amp in the vox booth as a headphone monitor? |
|
Definition
| Turn it on and set to Record to use it as a headphone monitor. |
|
|
Term
| Where are the T cables kept? |
|
Definition
| These cables are kept hanging by the computer monitor. |
|
|
Term
| Where are the mic cables kept? |
|
Definition
| These cables are kept hanging on the drum room wall by the fan room. |
|
|
Term
| What must you do before turning on the power supply for the bass mic in the control room? |
|
Definition
| Make sure all the bass mic cables are connected before doing this. |
|
|
Term
| When preparing to track bass in the control room, what setting must always be enabled? what must be disabled? |
|
Definition
| While setting up the bass track in the control room, the bass track should have its mute button ON. Its record-enable button should be OFF. |
|
|
Term
| What tape send does Console 3+4L go with? |
|
Definition
|
|
Term
| What do you have to be careful of when setting up SPR tom mics? |
|
Definition
| These mics fall off their clips easily. |
|
|
Term
| What should you remember when setting up overhead drum mics? |
|
Definition
| Overhead drum mics should be positioned so as not to get hit with the cymbals. |
|
|
Term
When should the green I be ON?
When should it be OFF? |
|
Definition
- ON when people are checking their signal before tracking (also OK while tracking)
- OFF when playing back a track that's in Record mode |
|
|
Term
| What should you always check before starting recording? |
|
Definition
|
|
Term
How do you turn an onscreen plug-in dial UP?
How do you turn it DOWN? |
|
Definition
UP: drag cursor up over the dial
DOWN: drag cursor down over the dial |
|
|
Term
| Where is the Melodyne plug-in located? |
|
Definition
| Inserts → RTAS plug-in → Other → [HERE} |
|
|
Term
| When recording a ruf mix back into Pro Tools, what must you do to the incoming track BEFORE recording? |
|
Definition
| Mute the incoming track beforehand. |
|
|
Term
| 3 steps to export a ruf mix? |
|
Definition
1. Highlight the entire audio region
2. Command + Shift + K
3. choose (or create) a rufs folder within that person's project folder as destination |
|
|
Term
| Do this to drag a COPY to another location |
|
Definition
|
|
Term
| Turn on/off Quick Punch Mode (2 methods) |
|
Definition
1. Numeric Keypad 6
2. Command + Shift + P |
|
|
Term
| Control plus up or down arrow |
|
Definition
| Keyboard shortcut for toggling through track height options on selected track |
|
|
Term
| Move cursor to previous edit seam or transient |
|
Definition
|
|
Term
| Return a fader to default value |
|
Definition
|
|
Term
| Put all tracks into Record Mode |
|
Definition
|
|
Term
| How to hide track and/or make inactive |
|
Definition
| Right-click on track name for a pulldown menu with these options |
|
|
Term
| Shortcut for importing session data |
|
Definition
|
|
Term
| Shortcut for zoom in or zoom out |
|
Definition
|
|
Term
| shortcut for the smart tool/MULTI TOOL |
|
Definition
|
|
Term
| shortcut to start recording (or start AND stop, if in Quick Punch mode) |
|
Definition
|
|
Term
| shortcut to export highlighted track to disk |
|
Definition
|
|
Term
| How to disable the reverb |
|
Definition
| Command + click on the bus that goes with the reverb |
|
|
Term
| 4 types of aux tracks in a typical session template? |
|
Definition
| 1. stereo reverb; 2. click; 3. talkback; 4. headphone mixes |
|
|
Term
| Aspects of session data you import using option + shift + I? |
|
Definition
|
|
Term
| Millennia HV3D channel 1 goes with what patch on the cabinet patchbay? |
|
Definition
| # 9 on cabinet-patchbay/ Millennia HV3D |
|
|
Term
| Take these 2 steps before listening back to takes |
|
Definition
1. Take all tracks out of Record mode
2. Turn off the green I |
|
|
Term
| What 2 things must happen before it's safe to disconnect mic cables? |
|
Definition
1. Turn off phantom power to the mic
2. Turn off the mic's power supply |
|
|
Term
| What reverb is typically used while tracking? |
|
Definition
|
|
Term
| Where is TDM Reverb located? |
|
Definition
| Insert A > TDM > Reverb > Reverb compact stereo |
|
|
Term
| Buses that reverb typically goes on |
|
Definition
|
|
Term
| Where you find the Click plugin |
|
Definition
| Insert A > TDM > Instrument > [HERE] |
|
|
Term
| Where the T cables go from/to when setting up an overall stereo mix |
|
Definition
| Mix L to tape send [odd #] and Mix R to tape send [even #] |
|
|
Term
| If the stereo mix is being sent to tape sends 15 and 16, when what inputs do you use in pro tools for it? |
|
Definition
|
|
Term
| Keyboard shortcut to turn Group A on and off |
|
Definition
|
|
Term
| How do you edit a track that's been Melodyned? |
|
Definition
1. Record the Melodyned audio into a new track
2. Make any fades and cuts in the new track |
|
|
Term
| Change something on all similar SELECTED channels |
|
Definition
| Option + shift + make change |
|
|
Term
| Stop recording and discard take |
|
Definition
|
|
Term
| Move playback location back OR forward |
|
Definition
| Command + Rewind OR Command + Fast Forward |
|
|
Term
|
Definition
| Command + click Record Enable button on a track |
|
|
Term
|
Definition
| Command + click Solo button on a track |
|
|
Term
|
Definition
|
|
Term
|
Definition
|
|
Term
|
Definition
|
|
Term
| go to song start shortcut |
|
Definition
|
|
Term
|
Definition
|
|
Term
| shortcut to create a new track |
|
Definition
| Command Shift N [apple shift N] |
|
|
Term
|
Definition
|
|
Term
| shortcut to duplicate track |
|
Definition
|
|
Term
|
Definition
|
|
Term
|
Definition
|
|
Term
|
Definition
|
|
Term
| How to put selected tracks into Record mode |
|
Definition
1. select tracks by shift-clicking on them
2. shift + option + click Record enable button on 1 of these selected tracks |
|
|
Term
| shortcut for Grabber tool |
|
Definition
|
|
Term
| shortcut for Trimmer tool |
|
Definition
|
|
Term
| Record-enable multiple tracks (pro tools 8 new feature) |
|
Definition
| with tracks selected, Shift + R |
|
|
Term
| How to place cursor at the BEGINNING or END of a selected region |
|
Definition
BEGINNING: down arrow
END: up arrow |
|
|
Term
| In Pro Tools 8, where do you click to change the track height? |
|
Definition
| The vertical bar between the level indicator and the timeline window. For audio tracks, it's a ruler, for MIDI tracks, it's a keyboard graphic. |
|
|
Term
| Use this menu to adjust the time, tempo, or meter of a song? |
|
Definition
|
|
Term
| Use this menu to access Disk Allocation |
|
Definition
|
|
Term
| what input does a click track have? |
|
Definition
| this kind of track has no input |
|
|
Term
| does a click track get a mono or a stereo output? |
|
Definition
|
|
Term
| if a plug-in or setting is bypassed, how does it appear? |
|
Definition
|
|
Term
| When record-enabling all tracks, what must you make sure to do first? |
|
Definition
| Make the stereo ruf track either MUTE or INACTIVE |
|
|
Term
| Do this to rename a track. |
|
Definition
| Control + click on track name and select "Rename" from the dropdown |
|
|
Term
| Where do you select a bus? |
|
Definition
| this is found under input or output, depending. |
|
|
Term
| 2 ways to bypass a plug-in? |
|
Definition
1- click bypass in the plugin window
2- command + click the plug-in name in inserts panel |
|
|
Term
|
Definition
|
|
Term
| When there's a group that you do want to include in playback, but don't want to record-enable along with all the other tracks, what should you do to that group of tracks? |
|
Definition
| Set these grouped tracks to no input |
|
|
Term
| When importing session data for the first time in a day, what should you do to make sure audio doesn't import as well as track setup? |
|
Definition
| In the Import dialogue box, deselect Import regions and playlists from the pulldown menu at the bottom right |
|
|
Term
| Is it possible to record-enable a group of tracks with a keystroke? |
|
Definition
| Yes, if you set the groups preference to enable group record-enable under "globals" in the groups dialogue box. However, the default is to manually record-enable the tracks in a group, which can be done with the mouse or the Command 8. |
|
|
Term
| how do you quickly locate the solo of a song (duh)? |
|
Definition
| look for the space between where the vox audio stops and starts again |
|
|
Term
| How do you change the meter of a song? |
|
Definition
| Event menu > Time Operations > Change meter |
|
|
Term
| What 3 basic things do you need to set in the Echo Farm plug-in before using it? |
|
Definition
1. Set the type of echo (like Deluxe Memory Man)
2. Set the tempo to match the song's tempo
3. Set the echo duration (either quarter notes or eighth notes, usually) |
|
|
Term
| how else can you turn off the click during recording, if you don't want to use the mouse? |
|
Definition
| mute the click track channel on the Command 8 on the |
|
|
Term
| How do you view different sets of channels on the Command 8? How do you move in groups of tracks instead of individual tracks? |
|
Definition
| Hit the right and left arrow buttons on the large wheel. To move R and L in groups of tracks, hit the Bank button. |
|
|
Term
| 8 steps for setting up a mic that needs a power supply? |
|
Definition
1. Connect mic via 7-pin (or other cable) to power supply's input.
2. Connect XLR cable from power supply output to patchbay in room where recording is taking place, or directly into preamp if in control room.
3. Connect power supply to wall outlet.
4. Finish connecting patchbay to preamp to patchbay to console to pro tools input.
4. Recheck to make sure all cables are connected.
5. Turn on power supply.
6. Turn on phantom power on preamp.
7. Let mic warm up.
8. Record-enable and have musician play to make sure there is signal. |
|
|
Term
| what should you do to the vox track when tracking overdubs? |
|
Definition
| lower the vox volume to -10 dB or so |
|
|
Term
| name some things you should check when creating a new session. |
|
Definition
1. disk allocation
2. bit depth and sample rate (24/96) |
|
|
Term
| what is the proper ratio of bit depth to sample rate for most professional tracking sessions? |
|
Definition
|
|
Term
| keystroke to move cursor to the next edit seam or transient |
|
Definition
|
|
Term
| keystroke to separate a region |
|
Definition
|
|
Term
| what's a way to make sure you are tracking overdubs on the correct take? |
|
Definition
| mute the previous takes so only the current one is showing. |
|
|
Term
| what do the #s on the bottom of the Neve pre correspond to? |
|
Definition
| the patch #s in the cabinet patchbay |
|
|
Term
| what should you check when importing a click track from another session? |
|
Definition
| check that the volume automation from the other song doesn't disrupt the click in the current session. |
|
|
Term
| with the multi tool selected, in the volume automation view, how do you get the pencil tool? |
|
Definition
| hold down the control key |
|
|
Term
| with the multi tool selected, in the volume automation viehow do you get the eraser tool? |
|
Definition
| hold down the control and the option key |
|
|
