Term
|
Definition
| ______________components in a series-parallel circuit may be in series with other components, or with other combinations of components. |
|
|
Term
|
Definition
| ____________components in a series-parallel circuit may be in parallel with other individual components, or with other combinations of components. |
|
|
Term
|
Definition
| The "Outside toward the Source" approach starts at the component ____________from the source. |
|
|
Term
|
Definition
| The "_________________" approach simplifies circuit analysis by combining and equating components. |
|
|
Term
|
Definition
| Total circuit power dissipation is equal to the ______________of all individual power dissipations in a series-parallel circuit. |
|
|
Term
|
Definition
| A short of any component in a series-parallel circuit always causes _________________ in power demand from the source |
|
|
Term
|
Definition
| A ____________voltage divider is an application of a series-parallel circuit. |
|
|
Term
|
Definition
| ___________voltage dividers are series circuits, while loaded voltage dividers are series-parallel circuits. |
|
|
Term
|
Definition
| A __________can be used as a variable voltage divider. |
|
|
Term
|
Definition
| A _______resistor helps regulate the output voltage of a power supply. |
|
|
Term
|
Definition
| A __________________ circuit may be used to match resistor values. |
|
|
Term
|
Definition
| In a series-parallel circuit, the same amount of current that leaves the negative side of the source must _________to the positive side of the source. |
|
|
Term
|
Definition
| Any component in a series-parallel circuit that is in series with another component that is open will have _____ _________ through it. |
|
|
Term
|
Definition
| Three resistors are connected in a series-parallel circuit. R1 = 1.0 ohm, 5% and is in series with a parallel combination of R2 = 2.0 ohms, 5% and R3 = 2.0 ohms, 5%. The total resistance of the circuit is _______. |
|
|
Term
|
Definition
| Three resistors are connected in a series-parallel circuit. R1 = 1.0 ohm, 5% and is in series with a parallel combination of R2 = 2.0 ohms, 5% and R3 = 2.0 ohms, 5%. The total resistance of the circuit is 2 ohms. If a 12-volt battery is connected to the circuit, the current flowing in the circuit is _______________. |
|
|
